Bedding plants

Splitting wood - you should note that

Splitting wood - you should note that

We are searching data for your request:

Forums and discussions:
Manuals and reference books:
Data from registers:
Wait the end of the search in all databases.
Upon completion, a link will appear to access the found materials.

Splitting wood is physically difficult work and often leads to accidents. Read here what you should definitely consider when chopping wood.

More and more people are switching to wood when heating because it is simply cheaper. Although wood has also become more expensive over the years, it is far from being as expensive as oil and gas.

Before you can use the wood for heating, you have to split the wood so that it fits into your fireplace.

The best time is actually after the impact. The small pieces dry faster and can be used for heating earlier. Fresh wood is also easier to split than dried wood.

2 ways to split wood

When chopping wood, you have 2 options for shredding it. Many still use a good ax. If you can dig a little deeper into your pocket, you can also choose a log splitter. These are particularly useful if you often have large quantities or split wood several times a year. They are available in different versions with different crown lengths. The performance and energy supply also vary for the many models.

Splitting wood - you should note that

Tip 1: The right tool

Chopping wood is one of the most demanding tasks in gardening. You can make your work a little easier if you pay special attention to your tool. Most probably use a conventional ax. Working with a real splitting ax is much more pleasant. For example with the Fiskars splitting ax X27. The wood is only chipped with it. Then it breaks apart in a wedge shape. I can highly recommend it!

You should also have a hammer and a few wedges ready to help you. Please make sure that the hammer and wedge are never made of the same material. So never hit steel on steel. Then metal splinters fly around your ears.

Tip 2: Check the functionality of the tool

Before you start splitting the wood, you should always check your tool. It is very important that the ax head sits firmly on the handle. If this is not the case, repair it immediately. Cracks or damage to the material should also be removed.

Tip 3: Wear protective clothing

To avoid accidents, you should wear protective clothing. Non-slip gloves are very important here so that the ax is firmly in your hand and does not fly around in one fell swoop.

You should also wear shoes with a steel toe cap so that the ax does not slip out of your hand and, in the worst case, you can cut off a toe. To protect the eyes from splinters, either protective glasses or a helmet with a protective visor are suitable.

Tip 4: Use wooden blocks

When chopping wood, use a block of wood as a base. If you keep hitting the ground and stones, your ax will eventually become blunt. It is also a more comfortable height for working. Your back will thank you.

Tip 5: split wood correctly

You need less effort when splitting wood if you hit the ax along the wood fiber. From time to time, small fiber tears appear on the wooden gap, which you can then take as a little help.

Tip 6: Hold firm

Chopping wood is a really heavy physical job and requires some strength. If you have a firm and correct stand on the wooden block, it will make your work a little easier.

Stand approximately in front of the block with your legs spread shoulder-width apart. Hold the ax in the middle with both hands and pull out over your head, then hit the log with full force.

Always make sure that the piece of wood is in an optimal and secure position. Accidents often happen here, too, because the log can tip over at the last moment and the ax hits at an unfavorable angle.

Tip 7: keep tools

When you have finished splitting the wood, you should not throw the tool in any corner before exhaustion, but put it in place properly. There should be protection on the cutting edge so that you don't injure yourself when you take it out later. Oil the cutting edge to protect it from rust.

If your ax has become dull over the years, you should have the cutting edge sharpened. So you will be ready for use again quickly.